v50 Steam/Premium information for editors
- v50 information can now be added to pages in the main namespace. v0.47 information can still be found in the DF2014 namespace. See here for more details on the new versioning policy.
- Use this page to report any issues related to the migration.
This notice may be cached—the current version can be found here.
Editing v0.31:Pressure plate
Jump to navigation
Jump to search
Warning: You are not logged in.
Your IP address will be recorded in this page's edit history.
You are editing a page for an older version of Dwarf Fortress ("Main" is the current version, not "v0.31"). Please make sure you intend to do this. If you are here by mistake, see the current page instead.
The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 40: | Line 40: | ||
You can [[power]] this from any source, but if your map gives 40 wind power you can just use a [[windmill]]. Build a [[windmill]] right above where it says "power here" and then build a [[gear assembly]] directly below it. Putting a windmill directly on top of a gear you disengage can cause the windmill to collapse, so don't try that unless it says the windmill has a stable foundation. You may also want to construct a wall around your windmill to prevent a [[building destroyer]] from smashing it. | You can [[power]] this from any source, but if your map gives 40 wind power you can just use a [[windmill]]. Build a [[windmill]] right above where it says "power here" and then build a [[gear assembly]] directly below it. Putting a windmill directly on top of a gear you disengage can cause the windmill to collapse, so don't try that unless it says the windmill has a stable foundation. You may also want to construct a wall around your windmill to prevent a [[building destroyer]] from smashing it. | ||
− | Now, whenever your pressure plate is triggered, the hatch will immediately open and dump the water from 1 onto the plate at 2, holding that plate down until you use your reset lever to activate the pump and put the water back on top of the hatch. Don't forget to turn the pumps off after all the water has moved, or it will continue to reset itself until the pumps are stopped | + | Now, whenever your pressure plate is triggered, the hatch will immediately open and dump the water from 1 onto the plate at 2, holding that plate down until you use your reset lever to activate the pump and put the water back on top of the hatch. Don't forget to turn the pumps off after all the water has moved, or it will continue to reset itself until the pumps are stopped. |
==Construction== | ==Construction== |